Temperature and dissolved oxygen recorded two PME Mindot O2 loggers in the Florida Keys from 11-17 July 2017 (NCEI Accession 0278679)

This dataset contains chemical and physical data collected during deployments Diodon_2017-07-11-12, Diodon_2017-07-13-14, Diodon_2017-07-15-16, and Diodon_2017-07-16-17 from 2017-07-11 to 2017-07-17. These data include O2 saturation and water temperature. The instruments used to collect these data include MiniDOT Logger. These data were collected by Markus Huettel of Florida State University and Peter Berg of University of Virginia as part of the "Collaborative Research: Robust optode-based eddy correlation systems for oxygen flux measurements in aquatic environments (Robust optode-based eddy correlation systems)" project. The Biological and Chemical Oceanography Data Management Office (BCO-DMO) submitted these data to NCEI on 2021-04-23.

The following is the text of the dataset description provided by BCO-DMO:

3OEC-instrument Temperature and Dissolved Oxygen

Dataset Description:
Acquisition Description:
Two PME Minidot loggers were deployed July 11-17, 2017 in a subtropical inner shelf environment (Salinity: 35-36, temperature: 28-31°C) approximately 9 km south of Long Key in the Florida Keys (24° 43.52'N, 80° 49.85'W). The site was located at 9 ± 1 m water depth near the center of a large flat carbonate platform covered with coral sand. The instruments were installed on the 3OEC instrument at ~35 cm above the sediment-water interface.

The temperature and oxygen data are the data recorded by factory-calibrated loggers:
Sampling rate is 1 /min
Oxygen range is 0 to 150%
Oxygen Resolution 0.01 mg/L
Oxygen Accuracy of +/- 1 mg/L
Response Time Approximately 30 seconds for oxygen

Temperature Range 0 to 35 degrees C
Temperature Resolution 10 millidigrees
Temperature Accuracy +/- 0.1 degrees C

The method of data analysis is reported in Huettel et al. (2020).